What To Know
- Locate the two screws on the back of the dryer that hold the top panel in place.
- Start with the smaller pulley on the motor and then work your way around to the larger pulley on the drum.
- Can I use any type of belt to replace the belt on my Miele dryer.
When your Miele dryer stops tumbling, it could be a sign that the belt has snapped. Replacing the belt is a relatively simple repair that you can do yourself with a few basic tools. Here’s a step-by-step guide on how to change the belt on your Miele dryer:
Safety First
Before you begin, unplug the dryer from the power outlet and allow it to cool completely. Failure to do so could result in electric shock or burns.
Tools and Materials
- New Miele dryer belt
- Screwdriver
- Pliers
- Flashlight (optional)
Step-by-Step Instructions
1. Remove the Top Panel
Locate the two screws on the back of the dryer that hold the top panel in place. Remove the screws and carefully lift the top panel up and off the dryer.
2. Locate the Belt
Once the top panel is removed, you will see the dryer drum and the belt wrapped around it. The belt is usually made of black rubber and is about 2 inches wide.
3. Remove the Old Belt
Using your pliers, grasp the old belt and pull it off the pulleys. Be careful not to damage the pulleys or the belt.
4. Install the New Belt
Take the new belt and place it around the pulleys. Start with the smaller pulley on the motor and then work your way around to the larger pulley on the drum.
5. Tension the Belt
Once the belt is in place, use your pliers to tension it. Pull the belt tight and then release it. The belt should be tight enough to prevent slipping but not so tight that it damages the pulleys.
6. Reinstall the Top Panel
Carefully lower the top panel back onto the dryer and secure it with the screws.
7. Test the Dryer
Plug the dryer back into the power outlet and turn it on. The dryer should now tumble smoothly.
Troubleshooting
If the dryer still does not tumble after replacing the belt, there may be another issue. Here are a few things to check:
- Make sure the belt is properly tensioned. If the belt is too loose, it will slip and the dryer will not tumble.
- Check the pulleys for damage. If the pulleys are damaged, they will need to be replaced.
- Inspect the motor. If the motor is not running, the dryer will not tumble.
Recommendations: DIY Success!
Replacing the belt on your Miele dryer is a relatively simple repair that you can do yourself. By following these step-by-step instructions, you can save yourself the cost of calling a repair technician.
Frequently Asked Questions
Q: How often should I replace the belt on my Miele dryer?
A: The belt on your Miele dryer should be replaced every 5-7 years or as needed.
Q: Can I use any type of belt to replace the belt on my Miele dryer?
A: No, you should only use a Miele-approved belt. Using the wrong type of belt could damage your dryer.
Q: How long does it take to replace the belt on a Miele dryer?
A: It should take about 30 minutes to replace the belt on a Miele dryer.
