Replacing the belt on your Electrolux dryer is a common repair task that can be easily accomplished with the right tools and instructions. In this comprehensive guide, we’ll walk you through the step-by-step process of how to replace the belt on your Electrolux dryer.
Tools and Materials You’ll Need:
- New Electrolux dryer belt
- Screwdriver
- Pliers
- Belt tension tool (optional)
Safety Precautions:
- Unplug the dryer from the electrical outlet before starting any repairs.
- Allow the dryer to cool down completely before handling any components.
- Wear gloves to protect your hands from sharp edges.
Step-by-Step Instructions:
1. Remove the Front Panel:
- Open the dryer door and locate the screws holding the front panel in place.
- Remove the screws and carefully lift the front panel off the dryer.
2. Disconnect the Belt:
- Locate the drive belt wrapped around the motor pulley and the drum pulley.
- Using pliers, gently pry the belt off the motor pulley.
3. Remove the Drum:
- Remove the screws holding the drum in place.
- Carefully lift the drum out of the dryer.
4. Install the New Belt:
- Place the new belt around the motor pulley.
- Stretch the belt over the drum pulley and secure it in place.
5. Reinstall the Drum:
- Carefully lift the drum back into the dryer.
- Secure the drum with the screws.
6. Reconnect the Belt:
- Using pliers, stretch the belt over the motor pulley.
- Ensure the belt is properly aligned and seated on both pulleys.
7. Adjust the Belt Tension:
- If you have a belt tension tool, use it to check the belt tension.
- Adjust the tension as needed to ensure the belt is not too loose or too tight.
8. Reinstall the Front Panel:
- Place the front panel back on the dryer and secure it with the screws.
9. Reconnect the Power:
- Plug the dryer back into the electrical outlet.
- Test the dryer by running a short cycle.
Troubleshooting:
- If the dryer makes a squealing noise, the belt may be too tight. Loosen the belt tension slightly.
- If the dryer doesn’t spin, the belt may be too loose. Tighten the belt tension slightly.
- If the belt breaks prematurely, it may be due to wear or damage. Replace the belt with a new one.
Wrapping Up:
Replacing the belt on your Electrolux dryer is a straightforward task that can save you the cost of calling a repair technician. By following these instructions carefully, you can ensure your dryer is running smoothly again in no time.
What You Need to Know
1. How often should I replace the belt on my Electrolux dryer?
- Electrolux recommends replacing the dryer belt every 5-7 years or as needed.
2. What are the signs of a worn dryer belt?
- Squealing noise during operation
- Dryer not spinning
- Belt breaking prematurely
3. Can I use a non-Electrolux belt on my Electrolux dryer?
- It is not recommended to use a non-Electrolux belt as it may not fit properly or perform as expected.
