Starting your Husqvarna leaf blower 125B can be a breeze if you follow the right steps. This comprehensive guide will provide you with all the necessary information to get your blower up and running effortlessly.
Safety First
Before starting your blower, ensure you wear appropriate safety gear, including eye protection, earplugs, and gloves. Disconnect the spark plug wire to prevent accidental starting during maintenance.
Fueling Your Blower
Your Husqvarna 125B leaf blower requires a mixture of unleaded gasoline and two-stroke engine oil. The recommended ratio is 50:1. Use fresh fuel and mix it thoroughly in a separate container before pouring it into the blower’s fuel tank.
Priming the Blower
Priming the blower helps draw fuel into the carburetor, making starting easier. Locate the primer bulb on the side of the engine and press it repeatedly until you feel resistance.
Checking the Choke
The choke helps enrich the fuel mixture for starting. When the engine is cold, move the choke lever to the “closed” position. As the engine warms up, gradually open the choke until it is in the “open” position.
Starting the Blower
1. Hold the blower firmly on the ground.
2. Pull the starter cord with a quick, firm motion.
3. Once the engine starts, allow it to idle for a few seconds before engaging the throttle.
Troubleshooting Starting Issues
- Engine won’t start: Check the fuel level, spark plug, and fuel filter. Ensure the air filter is clean and not clogged.
- Engine starts but dies: Adjust the carburetor settings, clean the fuel filter, or replace the spark plug.
- Engine runs rough: Clean the carburetor, adjust the idle speed, or check for air leaks.
Maintenance Tips
- Regularly clean the air filter to prevent engine damage.
- Replace the spark plug annually or more often if needed.
- Keep the fuel tank full to prevent air from entering the fuel line.
- Store the blower in a dry place to prevent corrosion.
Winterizing Your Blower
If you plan to store your blower for an extended period during the winter, follow these steps:
1. Drain the fuel tank and run the engine until it stops.
2. Remove the spark plug and pour a small amount of engine oil into the cylinder.
3. Pull the starter cord a few times to distribute the oil.
4. Replace the spark plug and store the blower in a cool, dry place.
Quick Answers to Your FAQs
Q: Why does my blower start but then die?
A: This could be due to a clogged fuel filter, carburetor issues, or a faulty spark plug.
Q: How often should I clean the air filter?
A: Clean the air filter every 25 hours of operation or more frequently if used in dusty conditions.
Q: What type of gasoline should I use?
A: Use unleaded gasoline with a minimum octane rating of 89.
Q: How do I adjust the carburetor?
A: Adjusting the carburetor is best left to a qualified technician. Improper adjustments can damage the engine.
Q: How can I prevent my blower from freezing in the winter?
A: Drain the fuel tank and run the engine until it stops before storing it. You can also add a fuel stabilizer to the fuel before storing.
