A clogged or malfunctioning drain pump can prevent your Miele dishwasher from draining properly, leaving you with a sink full of dirty dishes. Removing and replacing the drain pump is a relatively simple task that can be completed in under an hour. Here’s a step-by-step guide to help you get the job done:
Tools and Materials
- Phillips head screwdriver
- Flathead screwdriver
- Bucket or pan
- Towels
Safety First
Before you begin, unplug the dishwasher from the power outlet and turn off the water supply. This will prevent any electrical shock or water damage.
Step 1: Remove the Kickplate
Locate the kickplate at the bottom of the dishwasher. It is usually held in place by a few screws. Remove the screws and set the kickplate aside.
Step 2: Locate the Drain Pump
The drain pump is typically located at the bottom of the dishwasher, behind the kickplate. It is a small, black or gray cylinder with wires attached to it.
Step 3: Disconnect the Wires
Use a flathead screwdriver to disconnect the wires from the drain pump. Be careful not to damage the wires.
Step 4: Remove the Drain Hose
Locate the drain hose that is attached to the drain pump. Use a pair of pliers to loosen the hose clamp and disconnect the hose from the pump.
Step 5: Remove the Mounting Screws
There are usually four screws that hold the drain pump in place. Remove these screws and carefully lift the pump out of the dishwasher.
Step 6: Clean the Drain Pump
Inspect the drain pump for any clogs or debris. Use a small brush or a pair of tweezers to remove any obstructions.
Step 7: Reinstall the Drain Pump
Place the new or cleaned drain pump back into the dishwasher. Align the mounting holes and insert the screws. Tighten the screws securely.
Step 8: Reconnect the Drain Hose
Attach the drain hose to the drain pump and tighten the hose clamp.
Step 9: Reconnect the Wires
Connect the wires to the drain pump and make sure they are securely fastened.
Step 10: Reinstall the Kickplate
Place the kickplate back on the dishwasher and secure it with the screws.
Step 11: Test the Dishwasher
Plug the dishwasher back into the power outlet and turn on the water supply. Run a short cycle to test the drain pump and make sure it is working properly.
Troubleshooting Tips
- If the dishwasher is still not draining properly, check the drain hose for kinks or clogs.
- If the drain pump is making a loud noise, it may be faulty and need to be replaced.
- If you are unsure about any of the steps, consult the dishwasher’s user manual or contact a qualified appliance repair technician.
Wrapping It Up
Removing and replacing a Miele dishwasher drain pump is a straightforward process that can be completed in under an hour. By following these steps, you can save time and money by avoiding the need for a professional repair.
Information You Need to Know
Q: How often should I clean the dishwasher drain pump?
A: It is recommended to clean the drain pump every 3-6 months to prevent clogs and ensure optimal performance.
Q: What are the signs of a faulty drain pump?
A: Signs of a faulty drain pump include: dishwasher not draining properly, loud noises during operation, and water leaking from the bottom of the dishwasher.
Q: Can I replace the drain pump myself?
A: Yes, replacing the drain pump is a relatively simple task that can be completed by most homeowners with basic tools and knowledge.
